problems

  1. D

    Mira vortex waste problems

    Hi, Recently had one of these installed with new mira shower tray and having problems with slow drainage and sometime flooding. Cleaned it out ( as best I can given its design ) still having problems. Any solution please?
  2. B

    *Aberdeen* Pump and Powerflush Problems

    Hello, I'm looking for a plumber in the Aberdeen area to help with a pump problem. Ref: http://www.ukplumbersforums.co.uk/central-heating-forum/91735-grundfos-ups-15-50-fault-blockage.html If you think you can help and are available then private message me and we can arrange a time. Cheers!
  3. D

    Unvented Cylinder Pressure Problems

    good evening folks. hope all is well. i really need some help. a customers Santon PP 300e unvented cylinders heating elements had failed. i drained and replaced said elements. after allowing the system to re-fill and re-heat, i was made aware that the hot water was very hot, but that the hot...
    • dave knight
    • Thread
    • cylinder everything knowledge pressure problems thank unvented unvented cylinder
    • Replies: 13
    • Forum: Plumbing Jobs | The Job-board
  4. A

    40CDi combi problems

    Called to a leaking 40CDi, leak was coming from the flow turbine housing. The cartridge with the flow restrictor in it had perished a bit causing the leak. So ordered a new one and planned to go back tomorrow.... But the plot thickens.... I left the hot water switched off, but before i left...
  5. T

    Condensing problems?

    What causes condensing oil boilers to stop condensing? Ive been to a couple of boilers recently where the traps have dried up!! I dont have this problem with worcester bosch, mainly warmflow and grants, what causes this? My boss doesnt seem to answer me when i ask him about this, just says its...
  6. P

    Macerator problems

    Hi all anyone on here have any experience of Turboflush P macerator? It runs and pumps water out when the power is first switched on but isn't pumping when it fills up
  7. L

    Polypipe thermostat problems

    Hi, I've got a polypipe thermostat which controls my underfloor heating. The batteries recently went flat on the thermostat and the heating seemed to default to 'on' - the room temperature got to 25 degrees. I replaced the batteries and reset the date time etc but the heating is still on. I've...
  8. Hobo128

    Rothenberger rp30 problems

    Just bought said product . Pressure test kit. Blanked off the end to have a go but it doesn't seem to be charging. Am I missing something.
  9. M

    Pegler monobloc basin tap problems

    Hi I am new to this forum so I hope I'm doing it right. I have recently moved to another house which has three identical Pegler basin mixer taps however one appears not to be operating as per the other two. I think these taps are quite old and I have tried to provide a photo but so far no luck...
  10. M

    Anyone else having weird problems placing orders on Williams' site?

    Got a strange thing going on - can put stuff into my basket, go through the whole checkout process, billing address, delivery address, payment method, the whole lot works. As soon as I click the final "Submit order", it goes back to my basket, without taking the order. And just goes round and...
  11. KingDoey

    Waterfall tap problems

    Evening. I am in the process of fitting a new bathroom at mine. I have a waterfall mixer tap. See pic. At first it was fine but after ten mins the tap started spraying out at the side of the mesh on the outlet. It seems the mesh is not seated properly. Pushing it back in seems to remedy the...
  12. D

    Potterton profile problems

    I have a Potterton Profile 100e boiler that has started giving trouble. It's a fully pumped system. We went on holiday for 3 weeks, so I turned the boiler thermostat down low and set the programmer for one hour a day, just to keep it ticking over. When we got back, I reset the programmer and...
  13. C

    grant vortex combi 26e hot water problems

    Morning guys .I have a grant vortex combi 26e with hot water problems.I changed the TMV a month ago since then had H/W pressure problems so I descale heat exchanger for about two hours today is this long enough .?? Also once put it back together pressure on hot was better nut still fluctuations...
  14. C

    Pellet stove to buffer store circulation problems

    I have connected a 14kw pellet boiler stove to a 200 litre buffer tank. The original aim was to produce some lower temperature water for the underfloor heating circuit whilst feeding some rads upstairs. The boiler stove is fitted with a circulation pump on the return side. There is a 55 degree...
  15. andyplumber

    hot water system problems

    hello long time since i have been on here, wondering if anybody could help me with a problem with a old hot water system on a care home, the problem i have is no hot water pressure on the second floor, same floor the storage tanks are situated (300 gallons) at least 1 meter head from tap to...
  16. R

    Ideal icos 15 he problems

    Boiler is completely dead won't do a thing but display shows -. Any ideas guys. Boilers a pile of ****e
  17. P

    3 port valve problems

    Yet another problem with a new build system which is as follows, System boiler with zoned UFH to ground floor and radiator circuit / water tank upstairs. UFH is controlled by individual room programmers linked to actuators. Radiators / water tank governed by timer, thermostat, fed by 3 port...
  18. P

    shower problems

    hi all... I need a hand with a shower problem we have. I am a competent diyer (many years as a landlord!) - but am struggling with getting a shower back to good pressure. Ok, the main shower in our house was an exposed mixer (traditional look) with 22mm inlets - coming from a newish...

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock