Questions and plumbing advice in the Gas Engineers Forum - This is a PUBLIC Gas Engineers Advice Forum..
Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's
Forum Prefix Filter
Im fitting a kitchen in my own house . When removing the gas oven on a bayonet fitting and...
Baxi have changed their 600 and 800 ranges....they look completely different inside and out...
I've recently noticed some of the 'new' baxi boilers' cases going a bit yellow and am concerned...
Hi all. I hope you are well. Need some advice on this boiler and fault. E229. Went there and...
hello
After an engineer serviced our intergas boiler, the pressure was going down continuously...
What are engineers opinion on Intergas, I've installed a couple of these boilers for people and...
Too many ads now as i have to remove adblock anyone else getting cheesed off with this?
May...
Hi I didn't notice that the trap had water in there and when the pump came on it sucked some...
Morco feb 24ed3 has a f1 fault code. The burner reading is fine. The fault is intermittent...
Hi,
I turned my central heating on for the first time today this year and it started to bang...
If doing safety checks on a new oven. You check the fsd on the hobs are operating within...
- Question
I've had an idea to use a gas fired generator running on mains gas to top up a large off grid...
- Question
Hello
I’d like to replace gas cooker. Curry’s do install but I know they will refuse to install...
- Question
Hi,
Recently had a new heating system and unvented hot-water cylinder installed (conversion...
- Question
flue integrity test failed on a room sealed boiler however not effecting combustion and not...
I've got an inset fire which is slightly too big for the opening - the seals can't press against...
How would you classify this for a LL cert?
I've had a spate of low pressure issues recently.
MWP @ about 17.5mb
Centrica engineers are a...
If a domestic boiler/gas appliance is in a commercial property, does this mean a gas engineer...
Has any one come across a backplate elbow start leaking after 5 years because of a crack in it?
I saw on a plumerparts posts comments that the gas engineer always used an inline filter on the...
Can anyone tell me of a boiler equivalent to a Glow worm micron 30ff. I am not sure what one I...
The flue for a glow worm micron 30ff is apparently obsolete but there must be other flues that...
Hi guys
I'm moving to a flat but where the cooker is situated. I can't get a vented extractor...
My first post here, looking for some advice.
I've just had my boiler replaced with a worcester...
Hi everyone I currently work in oil and gas industry working in North Sea and further afield...
- Question
Hi guys,
any meter installers about?
im looking to complete a course to get CCN1 qualified and...
Hi all,
I have recently returned to the industry and have applied to Octopus for the upskill...
- Question
Has anyone managed to clean the tubes inside the manometer? I have dirt inside mine which has...
Hi all. Just need to clear my head around these changes.
I am guessing we do not need to put...
Hi,
I have a problem with Viessmann 111w
I have a Vicare sensor and app.
It goes like this :
If...
My installation has been classed as Dangerous 'Do not use' by my boiler manufacturer. I have an...
Hi all!
Have recently finished my training and am looking for anyone who would be willing to...
Hi everyone
My name is Daniel and I've recently completed my ACS gas engineer class room based...
- Question
Can anyone turn a boiler off to work around the flue for roofing as an example, as long as a...
Hi
Fitted a new out the box’s boiler today. It worked for 30 minutes. Then stoped and went to...
Hi, my mother had an electric cooker installed yesterday. The guy who fitted it said it...
Hi all. Got to run a Vailliant flue externally and been told by vailliant I need a heat...
Do you tend to go with the regulations in the gas safe books when installing these. Or the...
We are looking for Commercial Gas Engineers to join a Major company on various projects around...
- Question
Hi all, my plumber has installed a new boiler in place of the old one. The old one had a...
Please can anyone help or point me in the right direcrion. I have recently completed a 18 month...
Have some problems with my boiler that cant seem to get fixed. It's a worcester bosch greenstar...
Hi All,
I need your advise as I'm really concerned here. I only just had regular boiler replaced...
Hi, I am a homeowner but caught between a rock & a hard place.
I am trying to get a Vaillant...
I'm on a new build the boiler is in the garage. I have the option of drilling straight out with...
Hey folks, I'm wondering if someone could possibly help, I'm looking for a possible part...
Hey,
I'm a new entrant and I've just completed my 2 year training course and have my final week...
I’m at a loss with this one. We renovated a run down house and have lived in it now for about...
- Question
Hi all, I recently bought a tenement flat in Edinburgh which has never had gas but is in a stair...
Tags
Newest Plumbing Threads
-
Cold water issues in the top bathroom
- Started by Apex84
- Replies: 1
-
-
How much would you pay for a universal flush valve that enables replacements in under 5 minutes?
- Started by Professor
- Replies: 8
-
Bossing shower waste into soil pipe vs. separate shower waste- Started by CitizenErased
- Replies: 3
-
UK Advice on waste water pump in first floor flat
- Started by kbqwert
- Replies: 3
-
AM18x1 femail to 1/2" hose connector.
- Started by Adaminspace
- Replies: 0
-
Off grid shower and toilet solution needed
- Started by TpXThinnr
- Replies: 5