Mira Shower

[polmcm]

I done a straight change from a thermostatic shower to a new mira atom shower,when I run the shower in an upstairs ensuite it runs hot for a few seconds then goes back luke warm,I have a combi boiler,any advice please??.

 

[Chuck]

Are you sure that the hot and cold inlet connections to the shower unit the correct way round?

If you run a hot tap while the shower is running 'luke warm', i.e. increase the flow rate at the boiler, does the shower start working correctly?

How much flow do you have (in litre per minute) from the shower in 'luke warm' mode?

What is the hot water temperature setting on the combi?

What make / model of combi do you have?

 

[polmcm]

Are you sure that the hot and cold inlet connections to the shower unit the correct way round?

If you run a hot tap while the shower is running 'luke warm', i.e. increase the flow rate at the boiler, does the shower start working correctly?

How much flow do you have (in litre per minute) from the shower in 'luke warm' mode?

What is the hot water temperature setting on the combi?

What make / model of combi do you have?

Hot and cold defo right way round and no the shower actually goes colder if I run the hot tap,boiler is a Worcester 24cdi

 

[polmcm]

Hot and cold defo right way round and no the shower actually goes colder if I run the hot tap,boiler is a Worcester 24cdi

Just an update,the shower is in an ensuite upstairs a wee bit away from the boiler,if I run the hot tap at the sink then put the shower on its very hot for about 15 seconds then goes lyke warm.

 

[Chuck]

Fine, so it's probably not lack of flow that's the problem. What about the answers to my other questions:

How much flow do you have (in litre per minute) from the shower in 'luke warm' mode? (E.g. how long does it take to fill a jug, etc.?)

What is the domestic hot water temperature setting on the combi?

 

[polmcm]

Fine, so it's probably not lack of flow that's the problem. What about the answers to my other questions:

How much flow do you have (in litre per minute) from the shower in 'luke warm' mode? (E.g. how long does it take to fill a jug, etc.?)

What is the domestic hot water temperature setting on the combi?

The hot water on the boiler was set to max so I have got the shower working but only at minimum flow,next question is how do I change the temp on cartridge can't seem to locate any videos and instructions are vague,thanks for your help so far.very much appreciated.

 

[Chuck]

One last time:

How much flow do you have (in litre per minute) from the shower in 'luke warm' mode? (E.g. how long does it take to fill a jug, etc.?)

 

[polmcm]

One last time:

How much flow do you have (in litre per minute) from the shower in 'luke warm' mode? (E.g. how long does it take to fill a jug, etc.?)

I don't know how to measure this ??

 

[Chuck]

I don't know how to measure this ??

Hold a jug (or a bucket or basin) under the shower head (so it collects all the water coming out). Note the volume of water collected in a timed interval, say 30s. Tell us the time and volume of water collected.

From memory, the Mira Atom is a mixer bar that comes with a range of options for the spray head(s). The hand-held sprayer delivers about 9 litre per minute, the big fixed "drench" can heads require several times this. Your boiler can supply hot water for a shower of about 11 litre per minute (cold supply @10°C, shower outlet at 40°C)

The solution to your problem is probably going to be to fit an 'eco' shower head. If you like 'Hollywood' style showers you'll need to install a (big) hot water cylinder.

 

[polmcm]

I'm getting 3l p/m of hot water from boiler in basin next to shower and cold significantly higher,I've fitted an eco shower head which makes it barely usable,I'm going to get another shower,any recommendations of what to get ??