Press tool

[Arnoldheatnpipe]

I've used all of these machines a fair bit and to me they're all pretty similar, I slightly prefer rems because it stays on normal jaws for 42 and 54mm whereas geberit go to chains at that point which are a bit slower. just get the best priced one or the milwaukee if you already have that gear

 

[Gray0689]

Fair point. I haven't ever seen a composite pipe in 15mm though - only in 16mm. Which is damn annoying, when you have a van load of offcuts and can't use any of them on general work.

Until about 7 or 8 years ago, UFCH was often 16mm, but this offcut issue (amongst other things) has catapaulted Polypipe and JG Speedfit to market leadership.

Tectite (yorkshire) are doing mlcp pipe in 15mm now but not cheap