The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall and screwing back on. The same question regarding best type of wall plug for the job exists for both those options however, if I choose to remove that plate has anyone any idea how? They appear to be brass rings, rather than nuts, either side of the plate. I've tried gently to unscrew without success, but I haven't used too much force yet. The other question there is advice on how best to remove the residue of those old screws.
Discuss Mixer bar fitting solutions? in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net
Reply to Mixer bar fitting solutions? in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net
Similar plumbing topics
hi all
i hope you are all well
i'm planning to install my shower mixer on Saturday. today i was doing a dry fit and i wanted to show you some...
I need to replace the washer of my kitchen mixer tap as it is leaking. I was able to remove the spout once by unscrewing the screw on the back of...
I'm having a nightmare trying to find matt black wall or deck mounted bath mixer taps with 3/4 fitting that work on 0.2 bar.
From tank to tap, I...
I’m trying to replace a cartridge on a Grohe mixer tap but I can’t get beyond second stage!
I have removed the grub screw,but cannot lift off the...
Hi
I had to remove the glass panels from this quadrant shower cubicle and I'm struggling to get one of the screens back in place properly. The...